Kings 40A 12V DCDC Charger with 6m Solar Lead

LITHIUM (LIFEPO4) CHARGING

WITH PUSH BUTTON BATTERY SELECTION

With a specially programmed charge pattern specific to 12V Lithium (LiFePO4) batteries, plus the ability to easily switch to standard 12V lead acid, AGM, Gel or Calcium batteries with the press of a button, the Adventure Kings DCDC will work with just about any setup - and is easy to adapt to your future setups too!

The Kings DC Charger also has an automatic lithium ‘wake’ feature where it will attempt to wake up or ‘jump start’ a lithium battery where the BMS has disconnected due to low voltage.

BUILT IN MPPT SOLAR CONTROLLER/p>

WITH SOLAR PRIORITY CHARGING

The Kings 40A DCDC Charger has built in high-efficiency MPPT Solar Regulator that will track the maximum power point of a connected solar panel, so long as it has a minimum of 30W input. So you know you’re getting the most charge out of your panel no matter the conditions.

If, for example, you're driving at night and there is no solar input, the charger will pull only from your alternator.

When you stop at camp and turn off your vehicle, the DCDC will automatically swap over to solar charging.

If you're driving in the sun with both alternator and solar input, the DCDC will automatically prioritise solar input once it reaches the changeover threshold of 350W of solar power input.

2 METRE TEMPERATURE SENSOR

PRECISE CHARGING IN ANY CONDITIONS

Adventure Kings DC-DC Chargers can output their stated 40 Amps of charge even in extremely hot ambient temperatures of up to 50°C and internal temperatures around 80°C. There’s an internal temperature sensor that monitors the circuit board and electronics to protect and regulate the output of the automatic 5-stage current derating - plus there's the 2m long temp sensor with ring terminal, designed to mount to your battery highly accurate charge compensation.

BUILT TOUGH FOR SOLAR… OR ANY 12V SETUP

Specifically designed for portable solar the 2.5mm2 copper cables minimise voltage drop. Of course each wire is individually insulated, plus there’s an extra 1mm thick PVC protective sheath that covers both cables. The sheath is heat and water resistant and offers extra abrasion resistance too – perfect for your next trip away or your next DIY project!